tag:blogger.com,1999:blog-1301703939631167951.post5800740682893783171..comments2019-08-23T10:02:16.279-07:00Comments on SolidAPI: Extending SOLIDWORKS Interference DetectionMike Spenshttp://www.blogger.com/profile/00365628417064674695noreply@blogger.comBlogger1125tag:blogger.com,1999:blog-1301703939631167951.post-26548567956807372152017-06-12T03:18:53.813-07:002017-06-12T03:18:53.813-07:00I have an assembly with 2 parts. Keeping one part ...I have an assembly with 2 parts. Keeping one part stationary, I want to rotate another around a particular axis and find the exact position where the interference between these two parts just starts. And I have number of such pairs of parts for which I want to do the same. <br /><br />I have written an Add-In doing all this. It runs fine. But as I go on increasing the number of pairs, the program takes more and more time - e.g. for the first pair it takes say 1 minute but for the last pair the add-in almost takes 3 minutes. The entire program takes about 20 hours. <br /><br />Complexity of parts is same for all the pairs. How to increase this performance? <br /><br />My logic is - open parts, make an assembly, create mates, start rotating the movable part in steps and find the interference, stop when the interference is found. Repeat the same logic for the next pairs.<br /><br />Thanks and regards,<br />Bharati Page. Bharatihttps://www.blogger.com/profile/12068115271235992650noreply@blogger.com